Author Topic: Coupe Render  (Read 3000 times)

0 Members and 1 Guest are viewing this topic.

Offline CAClark

  • Sr. Member
  • ****
  • Posts: 285
    • ScorpioCGI
Coupe Render
« on: July 12, 2012, 07:54:16 am »
Hey all

I did this render earlier today.

Cheers!

Offline Dylan

  • Sr. Member
  • ****
  • Posts: 421
Re: Coupe Render
« Reply #1 on: July 12, 2012, 01:51:04 pm »
Nice one CA. How did you work the light spill?

Offline CAClark

  • Sr. Member
  • ****
  • Posts: 285
    • ScorpioCGI
Re: Coupe Render
« Reply #2 on: July 16, 2012, 03:23:53 am »
Thanks. I used Knoll Light Factory.

Cheers!

Offline Seghier

  • Full Member
  • ***
  • Posts: 182
    • My designs
Re: Coupe Render
« Reply #3 on: July 16, 2012, 04:29:45 am »
very nice CAClark :)
i have a little pointview about ground grid setup , can you show it ?

Offline CAClark

  • Sr. Member
  • ****
  • Posts: 285
    • ScorpioCGI
Re: Coupe Render
« Reply #4 on: July 16, 2012, 06:39:24 am »
Thanks, here you can see the ground grid.

Cheers!

Offline Seghier

  • Full Member
  • ***
  • Posts: 182
    • My designs
Re: Coupe Render
« Reply #5 on: July 16, 2012, 07:25:07 am »
thank you Clark
i think you try to reduce focal lenght , see in background propreties if exist the camera settings , just a point view

Offline CAClark

  • Sr. Member
  • ****
  • Posts: 285
    • ScorpioCGI
Re: Coupe Render
« Reply #6 on: July 16, 2012, 10:54:56 am »
Hey

I don't think the road lines are straight, or that the projected horizon should be that low. More specifically though, the Keyshot camera is configured to 50mm focal length which matches the exif data of the backplate image, so I'd be loathed to shorten the focal length. I could adjust the camera angle perhaps though.

Cheers!

Offline tsunami

  • Hero Member
  • *****
  • Posts: 683
Re: Coupe Render
« Reply #7 on: July 17, 2012, 04:22:03 am »
I love this work, as always greats jobs from you!!
Regards

Offline CAClark

  • Sr. Member
  • ****
  • Posts: 285
    • ScorpioCGI
Re: Coupe Render
« Reply #8 on: July 19, 2012, 09:55:41 am »
Thanks mate.

Cheers!