Author Topic: Creo to Keyshot  (Read 1635 times)

0 Members and 1 Guest are viewing this topic.

Offline caden2010

  • Newbie
  • *
  • Posts: 43
Creo to Keyshot
« on: November 03, 2011, 06:52:24 am »
Hi, I am working on (rendereing) a reasonably complex assembly at the moment. Normally I use Pro-E Wildfire 4 and from there export to KeyShot. As I have recently installed Creo I thought that I would install the Creo to KeyShot plug-in. All went well and is working perfectly.

Only question is file size. I exported the same file from Creo and Wildfire 4 and got 2 very different file sizes. WF4 - 203Mb and Creo 3Gb. Settings (as far as I can tell ) were the same using a tessolation of 0.15.

Can you please advise what I am doing wrong. For info the file from Creo in KeyShot runs just fine, does not appear to be any worst than the 203Mb file!

I have added a couple of images to show you the file sizes and also the assembly that I am working on.

Regards, Stuart

guest84672

  • Guest
Re: Creo to Keyshot
« Reply #1 on: November 03, 2011, 06:57:56 am »
I know - even at low tessellation value this CREO plugin is delivering pretty hefty files. We will address this.

Thanks for the feedback - can't wait to see the rendering!

Offline caden2010

  • Newbie
  • *
  • Posts: 43
Re: Creo to Keyshot
« Reply #2 on: November 03, 2011, 07:29:00 am »
Hi Thomas, thanks for the quick reply. I will hold off using the Creo plug-in for now.

It will be a while before the rendering is finished but I will post in on the forum when it's finished.

Regards, Stuart
« Last Edit: November 03, 2011, 07:48:31 am by caden2010 »