Author Topic: [Resolved] Holes in surface  (Read 141 times)

0 Members and 1 Guest are viewing this topic.

Offline Bob Savage

  • Newbie
  • *
  • Posts: 6
[Resolved] Holes in surface
« on: September 27, 2019, 02:53:28 pm »
The mesh is good in zbrush (I've had this design manufactured/cast), appears to be solid using plastic to render although there are dark spots in the areas where "holes" appear using a bronze metal, but with the metal there appear to be holes in the surface.  I thought it was lighting/angle but these appear open/black regardless of how I position the camera.

Any ideas what's causing it?

« Last Edit: October 16, 2019, 11:52:05 am by Justin A »

Offline Bob Savage

  • Newbie
  • *
  • Posts: 6
Re: Holes in surface
« Reply #1 on: October 12, 2019, 05:05:18 pm »
No big... Gimp solved the problem.

Offline MWo

  • Hero Member
  • *****
  • Posts: 898
  • Senior Technical Consultant @ INNEO (Germany)
    • german KeyShot page from INNEO Solutions
Re: Holes in surface
« Reply #2 on: October 12, 2019, 11:50:56 pm »
Have you tried to calculate the normals with edit geometry?