Author Topic: New fuji camera render  (Read 556 times)

0 Members and 1 Guest are viewing this topic.

Offline eRinconDesign

  • Newbie
  • *
  • Posts: 6
New fuji camera render
« on: April 14, 2019, 07:56:02 pm »
Hello Friends here there is my latest render, Recently I bought a more powerful machine so now I'm playing with settings and more elaborated textures. :)
But I might be doing something wrong cause.... they take too long. I add the shoots of the configuration. I don't think the values are that high. any ideas cause the render time was pretty long.

Thanks and please comment.!!! :)

Offline eRinconDesign

  • Newbie
  • *
  • Posts: 6
Re: New fuji camera render
« Reply #1 on: April 18, 2019, 11:04:42 pm »
Please community I will live some advide

Offline designgestalt

  • Full Member
  • ***
  • Posts: 179
Re: New fuji camera render
« Reply #2 on: April 20, 2019, 12:08:00 pm »
hello eRinconDesign,
bit tough to say something about "too long" without any further information.
I think 256 samples in custom mode is a bit overdone for this image, I am sure, you can go much lower.
make region renders of critical areas in the image and set the sample to 50 and see what it does. If this does not show the wanted result start increasing the samples in steps of 10 samples. this should bring down the rendertimes quite a bit. In fact I am just currently doing a set of renders for a customer, where I only use 80 samples for a comparable size image!

cheers designgestalt