KeyShot Forum

Technical discussions => Animation => Topic started by: Roberto Giussani on September 18, 2018, 05:23:08 am

Title: SHEET METAL BENDING ANIMATION
Post by: Roberto Giussani on September 18, 2018, 05:23:08 am
I use Solidedge but I have a problem:
If I make an animation for sheet bending in Solidedge ST9 with the parithetic (peer) variables it is not possible to export it to KeyShot 7.
Is there a way in KeyShot to create an animation of a sheet metal that is bend?
Thank you - best regards
Title: Re: SHEET METAL BENDING ANIMATION
Post by: ├ľner on November 08, 2018, 09:06:28 pm
Is there a way in KeyShot to create an animation of a sheet metal that is bend?

Hi, there is a way to bend a sheet metal.  i've bended too much in this way, please look at the attachment for description.